From 5ce219067f9b09b0eeafbf23360f524f546c6a95 Mon Sep 17 00:00:00 2001 From: hathach Date: Fri, 28 Mar 2014 17:56:06 +0700 Subject: [PATCH] md --- tinyusb/doxygen/get_started.md | 18 ++++-------------- 1 file changed, 4 insertions(+), 14 deletions(-) diff --git a/tinyusb/doxygen/get_started.md b/tinyusb/doxygen/get_started.md index 771ab1e75..17c4d1468 100644 --- a/tinyusb/doxygen/get_started.md +++ b/tinyusb/doxygen/get_started.md @@ -47,23 +47,13 @@ In order to build and run application demo, you would need To prevent any sort of problems, it is recommended to do **EXACTLY** as follows (esp the item 4) 1. Copy the whole repo folder to your lpcxpresso's workspace. -2. Click *File->Import*, then expand the *General* folder and select **Existing Projects into Workspace** and click Next - -![lpcxpresso_import.png](http://docs.tinyusb.org/images/lpcxpresso_import.png) - -3. On the next dialog, Click *Browse* and choose the **repo/demos** folder inside the repo. You should see a list of all demo applications - +2. Click *File->Import*, then expand the *General* folder and select **Existing Projects into Workspace** and click Next ![lpcxpresso_import.png](http://docs.tinyusb.org/images/lpcxpresso_import.png) +3. On the next dialog, Click *Browse* and choose the **repo/demos** folder inside the repo. You should see a list of all demo applications ![lpcxpresso_import2.png](http://docs.tinyusb.org/images/lpcxpresso_import2.png). - 4. **IMPORTANT** make sure the option **Copy projects into workspace** is **CLEAR**. As demo application uses link folders and this option may cause problem for the import. 5. Choose any of the demo application and click *Finish* -6. Select the configure corresponding to your development board - -![lpcxpresso_select_board.png](http://docs.tinyusb.org/images/lpcxpresso_select_board.png) - -7. Then select the correct MCU option from project properties then you are ready to go. - -![lpcxpresso_mcu.png](http://docs.tinyusb.org/images/lpcxpresso_mcu.png) +6. Select the configure corresponding to your development board ![lpcxpresso_select_board.png](http://docs.tinyusb.org/images/lpcxpresso_select_board.png) +7. Then select the correct MCU option from project properties then you are ready to go. ![lpcxpresso_mcu.png](http://docs.tinyusb.org/images/lpcxpresso_mcu.png) ### Keil ###