Jerzy Kasenberg
1503955860
dcd_da146xx: Clear transfer data on dcd_edpt_close
...
Closing endpoint clears data in affected xfer_ctl_t
2021-09-24 09:28:51 +02:00
Jerzy Kasenberg
f172c5ee13
dcd_da146xx: Remove registers pointer from xfer_ctl_t
...
Note: this commit does not change any logic.
xfer_ctl_t structure keeps all dynamic data connected with transfer.
It used to have pointer to register set that was constant and was there
for convenience only.
Removing register pointer from structure makes cleanup easier as whole
structure can be erased with memset like function.
In many cases functions were using local variable regs and xfer->regs which
were same, that could be confusing so this part is unified.
Few macros were added for easy conversion between epnum, xfer, and regs.
2021-09-24 09:28:51 +02:00
Jerzy Kasenberg
428eedcd04
dcd_da146xx: Update bus handling
...
So far bus reset was handled (with some holes in it).
Sleep and remote wakeup were not really tested and did not work.
With this change:
- bus reset is reworked
- remote wakeup works
- bus signal sleep is handled
2021-09-23 14:12:50 +02:00
Jerzy Kasenberg
c427712449
dcd_da146xx: Handle only enabled interrupts
...
Not much of an improvement but handle only interrupts
that were enabled and are expected.
2021-09-23 14:12:50 +02:00
Ha Thach
2eaf99e0aa
Merge pull request #1100 from kasjer/kasjer/da1469b_dk_usb-fix-button-config
...
da14695_dk_usb: Fix button configuration
2021-09-23 18:45:02 +07:00
Jerzy Kasenberg
417677aae4
da14695_dk_usb: Fix button configuration
...
Unlike da1469x_dk_pro, K1 pin (6) is connected to VCC when
active.
This adds required pull down and reverses active logic state.
2021-09-23 12:52:32 +02:00
Ha Thach
040300540c
Merge pull request #1099 from kasjer/kasjer/da1469x_dk_pro-fix-pin-pullup
...
da1469x_dk_pro: Fix button setup
2021-09-23 17:10:57 +07:00
Jerzy Kasenberg
dd2a518881
da1469x_dk_pro: Fix button setup
...
Button on board has 1k resistor to ground when pressed.
When not pressed pin 6 is floating.
This forces MCU pull-up for this pin for correct behavior.
2021-09-23 12:00:28 +02:00
Ha Thach
4766e7f348
Merge pull request #1093 from szymonh/master
...
Enforced buffer boundaries for hid devices
2021-09-23 13:31:46 +07:00
Scott Shawcroft
829f92d00f
Trying to setup the mmu
2021-09-22 15:19:02 -07:00
Ha Thach
3e569f8e79
Merge pull request #1094 from kasjer/kasjer/da146xx-vbus-handling
...
dcd_da146xx: Add VBUS handling
2021-09-18 23:12:40 +07:00
hathach
ea595d3161
update dcd attr for mm32
2021-09-18 16:53:16 +07:00
hathach
3333703d25
Merge branch 'master' into zhangslice-master
2021-09-18 13:35:26 +07:00
Scott Shawcroft
2499c9382d
rpi start. doesn't work
2021-09-17 16:51:34 -07:00
Ha Thach
90465299b4
Merge pull request #1086 from kkitayam/impl_close_all_for_khci
...
Implement dcd_edpt_close_all() and fix dcd_edpt_clear_stall() for frdm_kl25z
2021-09-17 21:40:40 +07:00
Jerzy Kasenberg
a71ac71d7f
da1469x_dk_xxx: Add VBUS handling
...
Two BSPs with DA146xx MCUs are now adopted to
VBUS handling changed introduced to dcd_da146xx driver.
da14695_dk_usb as bus-powered devices informs driver that
VBUS is present at startup.
da1469x-dk-pro has VBUS change interrupt handler that
informs driver about VBUS changes.
2021-09-17 12:20:57 +02:00
Jerzy Kasenberg
6d8677a78a
dcd_da146xx: Add VBUS handling
...
DA146xx are Bluetooth devices that may be battery
powered and when not connected to USB host there
is no need for USB peripheral to be running.
This change allows to enable USB peripheral when
VBUS is present otherwise USB is down reducing
power consumption.
tud_vsub_changed() function must be called
whenever VBUS change was detected.
For bus-powered devices this function should be called
at startup since VBUS must be present while device
is working.
2021-09-17 12:10:17 +02:00
hathach
b363afc091
minor clean up
2021-09-17 00:46:29 +07:00
hathach
c65cc75c6b
use correct resume detection for kl25z
2021-09-17 00:44:39 +07:00
hathach
8dfe0898e7
minor update to dcd khci
2021-09-17 00:43:10 +07:00
kkitayam
fbe1bf375c
Fix stall interrupt handling
2021-09-15 21:39:02 +09:00
kkitayam
46bb821753
Add J1-19 pin setting as a button
2021-09-15 21:32:53 +09:00
kkitayam
ecbe8c3376
Change default LED state to off
2021-09-15 21:32:53 +09:00
hathach
93ed3034c0
merge master and minor clean up
2021-09-15 18:35:52 +07:00
hathach
f39656b6d7
Merge branch 'master' of github.com:hathach/tinyusb into kkitayam-impl_close_all_for_khci
2021-09-15 18:29:28 +07:00
Ha Thach
03866ddf9b
Merge pull request #1062 from HiFiPhile/fifo_dcd_transdimension
...
Improvements for dcd_transdimension
2021-09-15 16:07:06 +07:00
MasterPhi
0ded1c5bac
Reset EP flags on close.
2021-09-14 21:08:12 +02:00
hathach
a23944035d
correct assoc_itf_count for bth driver
2021-09-15 00:51:01 +07:00
hathach
b474522245
make vendor driver more flexible
...
- skip additional custom descriptor between interface and endpoints
- can have up to 2 bulk endpoint ( 1 in & 1 out)
2021-09-14 21:30:38 +07:00
hathach
25ea8f9c9e
update configuration parser
2021-09-14 21:02:38 +07:00
MasterPhi
3639168066
Fix warning.
2021-09-14 11:58:22 +02:00
hathach
5404d6d8ae
usbd pre-compute total interface length without replying on driver open
2021-09-14 12:47:20 +07:00
hathach
103a11d449
add host hid_controller to cmake all list
...
fix 1067
2021-09-14 12:25:08 +07:00
Ha Thach
6d3fb7eb98
Merge pull request #1087 from HiFiPhile/nuc_wkp
...
NUC126: fix remote_wakeup
2021-09-14 11:40:55 +07:00
szymonh
2d6407e7a5
Enforced buffer boundaries for hid devices
2021-09-13 22:56:25 +02:00
Ha Thach
43aac7074b
Update supported.rst
2021-09-13 22:16:34 +07:00
Ha Thach
d640d59f99
Merge pull request #1092 from szymonh/master
...
Add support for Nucleo F412ZG
2021-09-13 22:14:23 +07:00
Ha Thach
1c3215257e
Merge pull request #1091 from hathach/esp32sx-compliance
...
Esp32sx compliance
2021-09-13 21:26:29 +07:00
szymonh
1a87b605bd
Add support for Nucleo F412ZG
2021-09-13 13:21:25 +02:00
hathach
cdc63459eb
esp32sx implement dcd_remote_wakeup(), fully compliance to chapter9 test suite
2021-09-13 16:49:38 +07:00
hathach
e64bfb9ff5
implement dcd_edpt_close_all(), pass chapter9 test suite (without remote wakeup)
2021-09-13 16:16:37 +07:00
Ha Thach
7e6f954ffe
Merge pull request #1090 from szymonh/master
...
Prevent buffer overflow in bth_device.c
2021-09-13 16:01:56 +07:00
szymonh
50e3c0054f
Add size check to tud_bt_hci_cmd_cb call in bth_device.c
2021-09-13 10:23:03 +02:00
hathach
43e6555fd0
clean up
2021-09-13 13:09:38 +07:00
hathach
ce5db06ba0
clear PID along with clear stall
2021-09-13 12:05:49 +07:00
hathach
6feda5ae8f
Merge branch 'nuc_wkp' of https://github.com/HiFiPhile/tinyusb into HiFiPhile-nuc_wkp
2021-09-13 11:52:16 +07:00
szymonh
d5f2c34eaa
Prevent buffer overflow in bth_device.c
2021-09-12 20:24:54 +02:00
hathach
9bed4e2e21
refactor nxp TDI dcd_edpt_xfer_fifo
2021-09-13 00:45:15 +07:00
hathach
038ec341f8
Merge branch 'fifo_dcd_transdimension' of https://github.com/HiFiPhile/tinyusb
2021-09-12 17:39:32 +07:00
Ha Thach
5013788989
Merge pull request #1089 from hathach/imxrt-compliance
...
Imxrt compliance
2021-09-12 13:37:49 +07:00