ESP32-S2 has only 5 available endpoint-in FIFOs (including EP0) but 7 available EP IN numbers. This change decouples the fifo number from the endpoint number, providing FIFO numbers until they reach the limit, at which point it will return false and assert an error that too many endpoints were allocated.
FIXME: Allow run-time selection to allow to handle both HS and FS with
one file
F746 HS port enumerates with error
config 1 interface 2 altsetting 0 bulk endpoint 0x3 has invalid maxpacket 64
Dialog Semiconductor's BLE MCU DA1469x comes with full speed USB.
It's base on National Semiconductor discrete USB controller USBN9603/4.
This adds support for:
- control/interrupt/bulk endpoints (up to 64 bytes)
- ISO endpoint were not tested and may not work correctly
- reset/sleep/wakeup are handled
- code for VBUS changes is provided
- Use register based XFRSIZ to determine transfer complete
(xfer->queued_len and xfer->short_packet were deleted)
- Pop out as many RxFIFO data entries as available within a IRQ call
- less application interruption due to XFRC calls
setup packet can complete together with previous status (in & out).
Always make sure to prepare valid buffer for holding setup packet when
queuing control status.
Changes:
- checking if tx buffer empty interrupt is masked
- process more than one packet in isr
- mask tx buffer empty just after all bytes were written
- use of transmit_fifo_packet instead of transmit_packet
For IN endpoints output FIFO is filled in interrupt, therefor before
endpoint is enabled, DIEPTSIZ is set with correct size of packet.
Then endpoint is enabled and FIFO empty interrupt is enabled.
This works fine except for the ZLP. Enabling FIFO empty interrupt
results in interrupt handler being called all the time because
there is nothing to put in the FIFO.
Eventually it ends when IN token is received and empty
packed is transmitted out.
This change does not enable FIFO empty interrupt for ZLP reducing
CPU load.
