hathach
dc00f0cae1
update link speed detection for nuc505
2020-07-16 20:44:06 +07:00
hathach
0517f4a2f1
dcd tdi report link speed on reset
2020-07-16 16:12:21 +07:00
hathach
5ca748a68e
rename CFG_TUD_MSC_BUFSIZE to CFG_TUD_MSC_EP_BUFSIZE
...
rename CFG_TUD_HID_BUFSIZE to CFG_TUD_HID_EP_BUFSIZE
2020-07-16 15:34:16 +07:00
hathach
fea6fb73a1
add fs & hs config for cdc_msc_freertos, midi_test, msc_dual_lun
2020-07-16 13:04:10 +07:00
hathach
706413f751
add tud_speed_get()
...
- define both fs and hs configuration descriptor
- rename CFG_TUD_CDC_EPSIZE to CFG_TUD_CDC_EP_BUFSIZE with default size of 64 for FS, and 512 for HS
2020-07-16 00:44:09 +07:00
Craig Hutchinson
323ae5a84f
Improve comment on CDC tud_cdc_write_available()
...
Fixes #460
2020-07-10 12:24:09 +01:00
Ha Thach
81392da1ea
Merge pull request #456 from me-no-dev/esp32-s2-epin-to
...
ESP32-S2: Detect EP IN Xfer Timeout
2020-07-10 12:29:06 +07:00
Ha Thach
dbced9911d
Merge pull request #447 from hathach/add-stm-hs
...
Add support for STM32 OTG HS core
2020-07-08 19:47:24 +07:00
hathach
0fd074afd8
change REDUCE_SPEED=0/1 to explicitly SPEED=high/full
...
update readme, boards.md to add link to new stm boards
2020-07-08 16:29:48 +07:00
Ha Thach
a192d99bf0
Merge pull request #457 from UweBonnes/add-stm-hs
...
Add stm hs
2020-07-05 14:07:08 +07:00
Uwe Bonnes
fd38178189
STM32/OTG_HS: Allow OTG_HS port to run at FS speed.
...
Add "REDUCE_SPEED=1" to the compile options.
2020-07-03 10:52:57 +02:00
hathach
ad5ae8c31d
update per review
2020-07-03 14:50:39 +07:00
hathach
a09a86d299
fix NVIC disable typo
2020-07-03 01:19:02 +07:00
me-no-dev
d493724a7b
ESP32-S2: Detect EP IN Xfer Timeout
...
In some rare ocasions (bad cable, noise, etc.) data transfer might timeout and hang the endpoint, unless the interrupt flag is cleared.
This pull request targets to solve that case.
2020-07-02 13:05:17 +03:00
hathach
4cec866994
correct HSE_VALUE in hal_conf
...
- although it is define in CFLAGS, it is worth to correct to be
consistent with other build
- extract set_speed()
2020-07-02 14:57:00 +07:00
hathach
9a290febcd
change default port some stm bsp
...
- f769disco default port is highspeed port1
- remove PORT0 on stlink since the board only populated HS connector
2020-07-02 11:58:40 +07:00
hathach
4966fb2e13
clean up
2020-07-02 01:25:21 +07:00
hathach
c2289777f7
Merge branch 'add-stm-hs' of github.com:hathach/tinyusb into add-stm-hs
2020-07-01 23:53:33 +07:00
Uwe Bonnes
196bdbc702
st/synopsys/dcd_synopsys.c: Remove USBC PHY PLL stabilization delay for now
...
While the ST code has a 2 ms stabilization delay for the USBC PHY PLL,
running without this delay showed no problem for at leat 10 USB un/replug
cycles. Observe for problems!
2020-07-01 14:45:07 +02:00
hathach
d2450abaaf
only set turnaround in reset complete
2020-07-01 18:51:04 +07:00
hathach
e3974d6869
correctly set turn around according to cpu clock
...
help to run with low speed mcu
2020-07-01 18:44:52 +07:00
hathach
a512a31c9d
Merge branch 'master' into add-stm-hs
2020-07-01 17:58:02 +07:00
hathach
ed1b670c55
clean up code
2020-07-01 17:57:37 +07:00
me-no-dev
6178f8de2f
ESP32-S2: Handle the fact that available EP IN FIFOs are less than the number of available EP INs
...
ESP32-S2 has only 5 available endpoint-in FIFOs (including EP0) but 7 available EP IN numbers. This change decouples the fifo number from the endpoint number, providing FIFO numbers until they reach the limit, at which point it will return false and assert an error that too many endpoints were allocated.
2020-07-01 13:38:59 +03:00
Ha Thach
0c9932440b
Merge pull request #452 from hathach/fix-dfu-rt
...
Fix dfu rt
2020-07-01 15:24:39 +07:00
hathach
12a145b27d
fix dfu-rt to response to SET_INTERFACE and DFU_GETSTATUS
...
fix #450
2020-07-01 01:33:02 +07:00
Jan Dümpelmann
378e6aab8c
Clear ep0_pending if rx short packet
2020-06-30 17:56:25 +02:00
Jan Dümpelmann
9e35ef73f7
Fix receiving of short packet data (ep out)
2020-06-30 12:55:39 +02:00
Uwe Bonnes
30a18e2605
stm32f723disco: USB HS enumerates.
2020-06-30 11:07:53 +02:00
Uwe Bonnes
05bfd9ac4a
dcd_synopsys: Handle HS and FS IP in one device
...
FIXME: Allow run-time selection to allow to handle both HS and FS with
one file
F746 HS port enumerates with error
config 1 interface 2 altsetting 0 bulk endpoint 0x3 has invalid maxpacket 64
2020-06-30 11:02:41 +02:00
hathach
ab75998316
Merge branch 'master' into add-stm-hs
2020-06-30 01:55:57 +07:00
Ha Thach
05996aee64
Merge pull request #427 from kasjer/kasjer/add-da1469x-support
...
Support for DA1469x MCU from Dialog Semiconductor
2020-06-30 01:20:56 +07:00
Ha Thach
268ab9eaa8
Merge pull request #399 from duempel/redesign_synopsys_receive
...
Improvements to Synopsys EP OUT
2020-06-29 16:02:40 +07:00
Jan Dümpelmann
99df7789a7
Add author name to dcd_synopsys.c
2020-06-29 10:55:03 +02:00
Jan Dümpelmann
4f69bcea7e
Remove EP0 remaining bytes manipulation
...
Renaming edpt_xact to edpt_schedule_packets
2020-06-26 17:18:25 +02:00
Jeff Epler
b2ef8cdd42
dcd_samd: Provide implementation for OPT_MCU_SAME5X
2020-06-25 18:51:04 -05:00
hathach
d4d6e06c1d
added OPT_MCU_SAME5X option
2020-06-24 00:53:17 +07:00
Gavin Li
7ae47a9397
Call tud_cdc_tx_cb right after flush to keep tx fifo full
2020-06-20 22:12:10 -07:00
Reinhard Panhuber
28505cf03e
Merge branch 'master' into uac2
...
Conflicts:
src/device/usbd.c
2020-06-20 11:10:35 +02:00
Reinhard Panhuber
ada82b840f
Get update from tinyusb.
2020-06-20 10:51:21 +02:00
Jan Dümpelmann
067287ef91
Add transaction (edpt_xact) as sub transfer
...
A transfer can have one or multiple transactions.
Usually only EP0 splits one xfer into multiple xact.
2020-06-18 17:18:28 +02:00
Mengsk
9ffb9b69a4
Disable SOF in dcd_stm32_fsdev
...
Signed-off-by: Mengsk <admin@hifiphile.com>
2020-06-18 14:18:00 +02:00
Gavin Li
8fe887198b
Add tx callback to cdc device
...
Useful for continuous transmission of data, which is difficult currently
because there is no notification of tx completion.
2020-06-18 01:13:44 -07:00
Mengsk
57b553e023
Fix IAR warnings.
...
Pa039 : use of address of unaligned structure member.
Pe188: enumerated type mixed with another type.
2020-06-17 10:08:33 +02:00
hathach
2b1c7730b7
fix hs port1 build with net endpoint
2020-06-16 00:53:06 +07:00
hathach
667eaa6dd6
fix stm32h743 priority with freeRTOS
2020-06-16 00:03:52 +07:00
hathach
2dd1be13e5
Enhance EP FIFO allocation for both Fullspeed and Highspeed
...
- Update shared RX FIFO calculation with FS/HS
- IN FIFO EP
- Interrupt -> use EPSize
- Bulk/ISO -> use max(EPSize, remaining-fifo / non-opened-EPIN)
2020-06-15 23:17:49 +07:00
Reinhard Panhuber
bc7e24b659
Fix wrong comment for IAD checks.
2020-06-14 14:22:10 +02:00
Jan Dümpelmann
4399dd1b06
cherry pick PR399 commit : Interrupt time improvements
2020-06-14 19:13:31 +07:00
hathach
f438aedccb
overwrite setup packet
2020-06-14 18:29:38 +07:00