move port reset & speed detection from isr context to usbh enumeration task
- decrease time in isr significantly from 50 ms to 580us
fix bug with osal_task_delay for freeRTOS buil
refractor list_find_previous_item & list_remove_qhd to act on ehci_link_t* instead of ehci_qhd_t*
fully support 1ms, 2ms, 4ms, 8ms for period list (each list has a dummy queue head)
- change period list structure
limit the maximum polling interval to 256 ms
add max_loop static MAX number of iteration for list_find_previous_item
add test for close 256ms polling interrupt
implementing freeRTOS integration
change get_period_frame_list from using lst_idx to hostid (fix bug)
adding polling interval supported for interrupt: 1ms, 2ms, 4ms, 8ms
- add interval_ms to get_period_head function
- add bInterval to qhd_init
- add support for sub-frame (less than 8 micro frames) interval
- add bunch of test for interrupt different intervals
rename tusb_bus_event_t to tusb_event_t
add test_mouse_init and more stuff for hidh mouse
move delay after port reset to only for speed detection
prioritize port change interrupt over xfer interrupt
- in case of unplugged, current connect change & xfer error both set
- xfer error only break to debugger if not because of unplugged
fix bug: set dev addr0 state to UNPLUG after close its control pipe in enumeration process
implement keyboard app code
- forcefully place keyboard_report in RAM section 3
change used bit in qtd from reserved in buffer[1] to alternate link
add code for fake ehci controller runs on period interrupt
change signature of tusbh_hid_keyboard_get_report
- tusb_keyboard_report_t* to uint8_t*
implement period (interrupt) complete isr processing
add test for usbh_isr error invoke
fix bug if device unplugged before is set to new address
- clean up & close control addr0 in usbh_device_unplugged_isr
- rename TUSB_DEVICE_STATE_READY to TUSB_DEVICE_STATE_CONFIGURED
- move device_state to core/tusb_types.h
- remove usbh_device_hcd_data_cleaned_up_cb, hcd now set the state directly
- add hal_debugger_is_attached & hal_debugger_breakpoint
- assert will suspend (place breakpoint) if the condition is failed and debugger is attached. Otherwise, a message to uart is printed
- fix get control qhd function when dev_addr is not zero (shifted 1)
- fix wrong logic for unsupported class
- add tests for pipe_close (while TDs are active)
- add tests for device unplugged
add tesst & implement the async_advance_isr to clean up "REMOVING" queue head
- add helper find previous qhd
- add remove qhd from async list
- add is_removing field for async advance isr to clean up
add pipe close for control pipe & bulk pipe (with tests)
add helper get qhd from pipe_handle
- interrupt source identifying
- for async list process
refractor control_xfer to use insert_qtd_to_qhd
- add test for control xfer interrupt processing
- add code for faking ehci controller async list scheduling & processing
- add prototype for void usbh_isr(pipe_handle_t pipe_hdl, uint8_t class_code);
- move control_request from ehci_data to usbh_device_info_pool
- add test for bulk transfer double (2 consecutive xfers)
- use table (array) structure for class driver, currently included
- refractor extract to function insert_qtd_to_qhd
+ init function
+ install_subtask
--> all class driver function must be declared with WEAK
