hathach
3ad0cd041b
clean up
2020-05-02 16:29:22 +07:00
hathach
ac3c645dc1
fix EP0 data toggle issue
2020-05-02 16:09:28 +07:00
hathach
2a479175ae
remove toggle walkaround, fix control stall race condition
2020-05-02 14:51:21 +07:00
hathach
a74a823b0a
fix dcd samd race condition with setup packet
...
setup packet can complete together with previous status (in & out).
Always make sure to prepare valid buffer for holding setup packet when
queuing control status.
2020-04-30 00:29:47 +07:00
Jan Dümpelmann
59ff208c65
Changed switch into if statements
2020-04-29 12:37:29 +02:00
Jan Dümpelmann
3e6feb7f6d
Redesign of Synopsys device transmission
...
Changes:
- checking if tx buffer empty interrupt is masked
- process more than one packet in isr
- mask tx buffer empty just after all bytes were written
- use of transmit_fifo_packet instead of transmit_packet
2020-04-29 11:32:22 +02:00
hathach
958b5510cb
added comment for hw clearing TXFE
2020-04-27 13:17:47 +07:00
hathach
e785b09118
TXFE is read only bit
2020-04-27 12:06:14 +07:00
hathach
00fcf829a1
sync synopsis fix for esp32s2
2020-04-26 22:41:04 +07:00
hathach
8d18d6077b
turn off TX FIFO Empty for EPIN if all bytes are written
...
fix dcd synopsys issue with usbnet #289
2020-04-26 22:14:59 +07:00
Jerzy Kasenberg
b949ae596f
synopsys: Reduce interrupt time for IN ZLP
...
For IN endpoints output FIFO is filled in interrupt, therefor before
endpoint is enabled, DIEPTSIZ is set with correct size of packet.
Then endpoint is enabled and FIFO empty interrupt is enabled.
This works fine except for the ZLP. Enabling FIFO empty interrupt
results in interrupt handler being called all the time because
there is nothing to put in the FIFO.
Eventually it ends when IN token is received and empty
packed is transmitted out.
This change does not enable FIFO empty interrupt for ZLP reducing
CPU load.
2020-04-24 17:38:30 +02:00
Jan Dümpelmann
551724498a
Added support for STM32F1 Connectivity Line MCU
...
STM32F105 and STM32F107 are using the Synopsys IP
2020-04-22 17:39:53 +02:00
hathach
1f442c0a9a
also add wakeup event
2020-04-18 23:48:36 +07:00
hathach
c3fc5f1595
session end interrupt doesn't trigger on esp32 saola board
...
it is possibly due to the board design without vbus sense. Revisit
later.
2020-04-18 23:42:51 +07:00
hathach
fa71402e17
implement disconnection detection for stm32 synopsys
...
- disconnection is OTG INT session end bit
- add USE_SOF to disable 1ms interrupt on mcu which isn't used now by
the stack
- add suspend detection
2020-04-18 23:40:27 +07:00
hathach
6f9c256ad0
complete remove dcd_set_config(), fix unit test
2020-04-17 13:52:34 +07:00
hathach
05476d9ad7
Merge branch 'master' into remove-dcd-set-config
2020-04-17 13:38:22 +07:00
Ha Thach
85f0894fff
Merge pull request #347 from majbthrd/nuc505_config
...
nuc505: change dcd_set_config() behavior
2020-04-17 13:36:16 +07:00
Ha Thach
1f69807621
Merge pull request #354 from hathach/cxd56-disconnect-connect
...
Cxd56 disconnect connect
2020-04-17 13:12:47 +07:00
hathach
dddf30f532
added disconnect for spresense
2020-04-17 12:53:42 +07:00
hathach
50be9d7c3a
mass rename tud/dcd_irq_handler to tud/dcd_init_handler
2020-04-17 12:27:53 +07:00
hathach
89f99426fc
add code for disconnect/connect (not tested)
2020-04-17 11:48:49 +07:00
Ha Thach
4bbbba48cb
Merge pull request #351 from hathach/valentyusb-dcd-disconnect-connect
...
Valentyusb dcd disconnect connect
2020-04-17 09:52:29 +07:00
Ha Thach
19e2eb66c0
Merge pull request #350 from hathach/synopsys-msp430-dcd-disconnect-connect
...
Synopsys msp430 dcd disconnect connect
2020-04-17 09:51:15 +07:00
Ha Thach
9aa553ccc2
Merge pull request #352 from hathach/samg-dcd-disconnect-connect
...
samg implement dcd connect/disconnect
2020-04-16 23:14:42 +07:00
Ha Thach
33610751d7
Merge pull request #336 from pigrew/edpt_close
...
> If you notice my chain of events above, the bulk transfer was started BEFORE the SET_INTERFACE call. The USB device hardware swaps the order of them being delivered. On STM32, it gives priority to the lower-numbered EP index.
It shouldn't be a matter, control is 2+ stage, before sending the setup. Host should stop all communication to the endpoint that It wants to close.
2020-04-16 23:10:36 +07:00
hathach
36d4efa077
samg implement dcd connect/disconnect
2020-04-16 22:59:19 +07:00
hathach
6377699d77
implement dcd disconnect connect
2020-04-16 22:30:33 +07:00
hathach
3aaad8cd73
add int enable/disable for pullup
2020-04-16 21:30:12 +07:00
hathach
18d936b414
msp430 disconnect/connect
2020-04-16 21:04:28 +07:00
hathach
63655ac9d7
cleanup for esp32
2020-04-16 20:43:26 +07:00
hathach
4c74140b31
stm32 sysnopsys disconnect/connect
2020-04-16 20:20:20 +07:00
hathach
a009775745
dcd disconnect/connect for transdimension ip
2020-04-16 16:56:16 +07:00
hathach
418b69f2db
implement dcd disconnect/connect for lpc ip3511
2020-04-16 16:05:57 +07:00
hathach
969121df4f
added dcd disconnect/connect to lpc17/40
2020-04-16 15:52:45 +07:00
Peter Lawrence
b9fca0bbb4
nuc505: change dcd_set_config() behavior
2020-04-15 14:16:48 -05:00
Nathan Conrad
b0270f499b
stm32fsdev: dynamic allocation of PMA.
2020-04-15 11:53:30 -04:00
Nathan Conrad
16f65890eb
Merge branch 'master' into edpt_close
2020-04-14 10:22:03 -04:00
Nathan Conrad
bbc59f1ceb
stm32fsdev: add static assert for PMA size bigger than EP0 size.
2020-04-13 20:50:17 -04:00
Nathan Conrad
f8e7487355
edpt_close: Updated based on feedback.
2020-04-13 09:51:46 -04:00
hathach
f4df829399
lpc17xx move set configdevice into set address
...
for removing dcd_set_config()
2020-04-13 17:04:18 +07:00
Nathan Conrad
0eeaccaf46
Skeleton, and initial stm32fsdev implementation (that leaks memory)
2020-04-12 21:27:27 -04:00
Ha Thach
04a06ec401
Merge branch 'master' into refactor-irqhandler
2020-04-11 15:49:34 +07:00
Ha Thach
13a3081d30
Merge pull request #333 from hathach/fix-esp32s2-setup-packet
...
fix incorrect setup packet
2020-04-11 15:18:41 +07:00
Ha Thach
07809d03a7
Merge pull request #332 from pigrew/stm32fsdev-dcdconnect
...
stm32fsdev: Implement dcd_connect.
2020-04-11 13:20:31 +07:00
hathach
ae1314f1c7
fix incorrect setup packet
...
also increase usbd stack in example when debug is enabled
2020-04-11 12:55:45 +07:00
Ha Thach
2ff3f765db
Merge pull request #319 from hathach/add-esp32s2
...
port ESP32 S2
2020-04-10 23:53:03 +07:00
hathach
a37a56acd3
remove CONFIG_IDF_TARGET_ESP32S2BETA per review
2020-04-10 23:38:36 +07:00
Nathan Conrad
5bd9d14fc1
stm32fsdev: set dcd_connect API definitions to strong, Modify documentation.
2020-04-10 10:26:41 -04:00
hathach
8953bc9255
added comment note for beta chip walkaround
2020-04-10 20:25:53 +07:00
