Fix handling of interrupt endpoints. i.e. no ZLPs.
Fix the assignation of endpoint types.
Add button support for MM900evx boards.
On board support do not block for UART input.
Correct USB FIFO use for setup data phases (OUT transfers). We cannot stop traffic on the control endpoint so we set a flag and pull data from host when tinyUSB requests it from the USB FIFO. Extend this for all endpoints although currently not required.
Rename all instances of ft90x which can apply to ft93x as ft9xx.
Add support for the cdc_dual_ports example for ft9xx.
Add LED pin definition for board LED in a simple to access place on the Bridgetek MM900EVx boards.
The SetLineCoding would fail as host would send the SETUP OUT phase before tinyUSB had setup a transaction for it. ft9xx port would ignore the transfer since there was no valid transaction setup for it. One SETUP data phase packet is cached now.
Removing the Hardcoded interface numbers from the video descriptors allow the user to add other interfaces before or after the Video Control Interface and Video Streaming Interface
- remove "-Wno-stringop-overflow -Wno-array-bounds"
- skip -Wconversion for gcc 9 and prior
- suppress_tinyusb_warnings only when building with gcc 9 and below
* gcc 9.2.1 has some spurious -Wconversion warnings
* cmake 3.18 and above require set_target_properties to be added from the target directory (so added it to all examples)
* fixed a few warnings in a couple of examples
since HS interrupt endpoint can be up to 1024, 8-bit is not enough.
affected APIs are:
- tud_hid_n_report() / tud_hid_report()
- tud_hid_report_complete_cb()
* Removed some compiler warnings, and cleaned out unnecessary warning suppression from CMake suppress_tinyusb_warnings()
* Made explicit family_configure_dual_usb_example() for DUAL mode examples as family_configure_target() may not generally be called multiple times for the same target
* Renamed library pico_pio_usb to tinyusb_picio_pio_usb to be clearer and avoid conflict if someone already has a pico_pio_usb in their project
* Added family_add_pico_pio_usb() method for adding Pico-PIO_SUB support to an existing example
* Allowed tinyusb_pico_pio_usb to be added to regular apps using the Pico SDK
