MCU_DIR = hw/mcu/dialog/da1469x include $(TOP)/$(BOARD_PATH)/board.mk CFLAGS += \ -flto \ -mthumb \ -mthumb-interwork \ -mabi=aapcs \ -mcpu=cortex-m33+nodsp \ -mfloat-abi=hard \ -mfpu=fpv5-sp-d16 \ -DCORE_M33 \ -DCFG_TUSB_MCU=OPT_MCU_DA1469X \ -DCFG_TUD_ENDPOINT0_SIZE=8\ LDFLAGS_GCC += \ -nostdlib \ --specs=nosys.specs --specs=nano.specs # All source paths should be relative to the top level. LD_FILE = $(FAMILY_PATH)/linker/da1469x.ld # While this is for da1469x chip, there is chance that da1468x chip family will also work SRC_C += \ src/portable/dialog/da146xx/dcd_da146xx.c \ ${MCU_DIR}/src/system_da1469x.c \ ${MCU_DIR}/src/da1469x_clock.c \ ${MCU_DIR}/src/hal_gpio.c \ SRC_S += $(FAMILY_PATH)/gcc_startup_da1469x.S INC += \ $(TOP)/$(BOARD_PATH) \ $(TOP)/${MCU_DIR}/include \ $(TOP)/${MCU_DIR}/SDK_10.0.8.105/sdk/bsp/include # For freeRTOS port source FREERTOS_PORTABLE_SRC = $(FREERTOS_PORTABLE_PATH)/ARM_CM33_NTZ/non_secure # flash using jlink but with some twists flash: flash-dialog # SDK_BINARY_PATH is the path to the SDK binary files SDK_BINARY_PATH = $(HOME)/code/tinyusb-mcu-driver/dialog/SDK_10.0.8.105/binaries MKIMAGE = $(SDK_BINARY_PATH)/mkimage $(BUILD)/$(PROJECT)-image.bin: $(BUILD)/$(PROJECT).bin @echo '#define SW_VERSION "v_1.0.0.1"' >$(BUILD)/version.h @echo '#define SW_VERSION_DATE "'`date +"%Y-%m-%d %H:%M"`'"' >> $(BUILD)/version.h $(MKIMAGE) da1469x $^ $(BUILD)/version.h $^.img cp $(TOP)/$(FAMILY_PATH)/product_header.dump $(BUILD)/$(PROJECT)-image.bin cat $^.img >> $(BUILD)/$(PROJECT)-image.bin flash-dialog: $(BUILD)/$(PROJECT)-image.bin @echo r > $(BUILD)/$(BOARD).jlink @echo halt >> $(BUILD)/$(BOARD).jlink @echo loadfile $^ 0x16000000 >> $(BUILD)/$(BOARD).jlink @echo r >> $(BUILD)/$(BOARD).jlink @echo go >> $(BUILD)/$(BOARD).jlink @echo exit >> $(BUILD)/$(BOARD).jlink $(JLINKEXE) -device $(JLINK_DEVICE) -if $(JLINK_IF) -JTAGConf -1,-1 -speed auto -CommandFile $(BUILD)/$(BOARD).jlink