/* * The MIT License (MIT) * * Copyright 2021 Bridgetek Pte Ltd * * Permission is hereby granted, free of charge, to any person obtaining a copy * of this software and associated documentation files (the "Software"), to deal * in the Software without restriction, including without limitation the rights * to use, copy, modify, merge, publish, distribute, sublicense, and/or sell * copies of the Software, and to permit persons to whom the Software is * furnished to do so, subject to the following conditions: * * The above copyright notice and this permission notice shall be included in * all copies or substantial portions of the Software. * * THE SOFTWARE IS PROVIDED "AS IS", WITHOUT WARRANTY OF ANY KIND, EXPRESS OR * IMPLIED, INCLUDING BUT NOT LIMITED TO THE WARRANTIES OF MERCHANTABILITY, * FITNESS FOR A PARTICULAR PURPOSE AND NONINFRINGEMENT. IN NO EVENT SHALL THE * AUTHORS OR COPYRIGHT HOLDERS BE LIABLE FOR ANY CLAIM, DAMAGES OR OTHER * LIABILITY, WHETHER IN AN ACTION OF CONTRACT, TORT OR OTHERWISE, ARISING FROM, * OUT OF OR IN CONNECTION WITH THE SOFTWARE OR THE USE OR OTHER DEALINGS IN * THE SOFTWARE. * * This file is part of the TinyUSB stack. */ #ifndef BOARD_H_ #define BOARD_H_ // Note: This definition file covers all MM900EV1B, MM900EV2B, MM900EV3B, // MM900EV-Lite boards. // Each of these boards has an FT900 device. #ifdef __cplusplus extern "C" { #endif // UART is on connector CN1. #define GPIO_UART0_TX 48 // Pin 4 of CN1. #define GPIO_UART0_RX 49 // Pin 6 of CN1. // LED is connected to pins 4 (signal) and 2 (GND) of CN2. #define GPIO_LED 36 // Button is connected to pins 6 (signal) and 2 (GND) of CN2. #define GPIO_BUTTON 37 // Remote wakeup is wired to pin 40 of CN1. #define GPIO_REMOTE_WAKEUP_PIN 18 // USB VBus signal is connected directly to the FT900. #define USBD_VBUS_DTC_PIN 3 // Enable the Remote Wakeup signalling. #define GPIO_REMOTE_WAKEUP #ifdef __cplusplus } #endif #endif