//--------------------------------------------------------------------------------
// SimWrapper.v
// Konstantin Pavlov, pavlovconst@gmail.com
//--------------------------------------------------------------------------------

// INFO --------------------------------------------------------------------------------
//


CAUTION !
THIS CODE IS OBSOLETE NOW. PLEASE USE "uart_tx.sv", "uart_rx.sv" BLOCKS
AND THEIR TESTBENCHES INSTEAD


`timescale 1ns / 1ps

module SimWrapper();

reg clk200;
initial begin
        #0 clk200 = 1;
        forever
            #2.5 clk200 = ~clk200;
end

reg rst;
initial begin
        #10.2 rst = 1;
        #5 rst = 0;
        //#10000;
        forever begin
            #9985 rst = ~rst;
            #5 rst = ~rst;
        end
end
wire nrst = ~rst;

reg rst_once;
initial begin       // initializing non-X data before PLL starts
        #10.2 rst_once = 1;
        #5 rst_once = 0;
end
initial begin
        #510.2 rst_once = 1;    // PLL starts at 500ns, clock appears, so doing the reset for modules
        #5 rst_once = 0;
end
wire nrst_once = ~rst_once;

wire [31:0] DerivedClocks;
ClkDivider CD1 (
    .clk(clk200),
    .nrst(nrst_once),
    .out(DerivedClocks[31:0]));
defparam CD1.WIDTH = 32;

wire [31:0] E_DerivedClocks;
EdgeDetect ED1 (
    .clk(clk200),
    .nrst(nrst_once),
    .in(DerivedClocks[31:0]),
    .rising(E_DerivedClocks[31:0]),
    .falling(),
    .both()
    );
defparam ED1.WIDTH = 32;

wire [15:0] RandomNumber1;
c_rand RNG1 (
    .clk(clk200),
    .rst(rst_once),
    .reseed(1'b0),
    .seed_val(DerivedClocks[31:0]),
    .out(RandomNumber1[15:0]));

reg start;
initial begin
        #100.2 start = 1;
        #5 start = 0;
end


wire txd_pin;
wire txbusy_pin;

UartTx UT1 (
    .clk(clk200),
    .nrst(nrst),

	.tx_data(RandomNumber1[7:0]),
	.tx_start(1'b1), // .tx_start(~|RandomNumber1[15:10]),
	.tx_busy(txbusy_pin),
	.txd(txd_pin)
    );
defparam UT1.CLK_HZ = 200_000_000;
defparam UT1.BAUD = 100_000_000;

UartRx UR1 (
    .clk(clk200),
    .nrst(nrst),

	.rx_data(),
	.rx_busy(),
	.rx_done(),
	.rxd(txd_pin)
    );
defparam UR1.CLK_HZ = 200_000_000;
defparam UR1.BAUD = 100_000_000;

endmodule