- Using new packet interface
- Adding active signal, indicating that link is ready. This way you don't need to guess when the link is ready (no magic constants)
- Removed register on por reset input to get rid of x on startup.
- holding rx in reset state until tx is done
- removing reset from all pipeline registers
- removing reset from oddr/iddr
- the idea is to keep things quiet not to block in lots of places. The only real block needed is in the FIFO to keep "noise" from propagating past the link. The link should be kept in a safe reset state until the rx fram is stable and the clock is running so that the pipe can be cleaned out.
- more modular
- two bits cominng from sys_clk elink config domain
- drives the tx and rx from top level elink
- from software you would probably write 2'b11 to reset both at same time
-moving clock and reset outside basic elink
-adding idelay reference clock
-separate and synchronized reset for each domain
-adding proper reset to fifo_cdc (per domain, not asynch)
-moving to "real" Xilinx PLL instantiation
-one PLL for CCLK one for LCLK
-removing clock dividers, can't work at speed, put inside model
-configuration needs to be done differently
-removing pll_bypass signal, can't work with logic
-clocks should be done with hard macro primitives (no logic)
-There is now only one clock domain crossing involved with the reg files/ All clock domain crossings use the same 104 bit wide async fifo! If it's broken we are screwed, if it works we are perfect!
-Configuration can be done from host through txwr/txrd path of any register
-The RX IO pins can only access the RX side of the design
-Access without symmetry was awkward, now we can reach regs from TX or RX side
-Removes a special path for mailbox (came for free)
-At the same time reduced clock complexity (one clock for system!!)
-Moved mailbox to top level
-Changed main clock to "sys_clk" for all
-A read on transmit side initiates timer
-Timer is reset when read request comes back
(assumption last read requests starts timer..last return stops it)
First time ever using spell cheker in EMACS. Hard to believe...but it's true!
I am sure this speaks volume for how little I have commented my code over the years!
-pll bypass for clocks (customer request)
-adding dividers on all clocks (tx/cclk)
-adding reset block (clearer)
-using commong clock_divider block
-need to clean up divider block later today, slightly broken:-)
-added register read/write properly
-removed redundant wrapper layers in maxi/saxi
-changed over to "emesh" interface from packet 103 bit data
-cleaned up maxi
-cleaned up saxi
-removed redundant signals in elink interface (user,lock,..)
-added wrapper to fifo (to carry emesh interface through)
Now comes the fun part of testing
Our "standard packet" order should be followed everywhere to ease verification and integration (standards are good fir reuse...):
[0]=access
[1]=write
[3:2]=datamode
[7:4]=ctrlmode
[39:8]=dstaddr
[71:40]=data
[103:72]=upper-data (or srcaddr)
-adding clock bypass mode for esystx[12]
-removing monitor feature on erx
-remove loopback support from doc
-add clock bypass mode for esysclk
-shortening register names (descriptive enough)
-added debug signal information
-moving registers to elink
-making elink version programmable (to support plug in boards)
-reorganized debug signals and added stickys
-added timeout for axi slave
-removed embox status bit (redudant, don't poll status)
-renamed EMBOX0-->EMBOXLO
-moved datain interface straight to ecfg (cleanup)
-changed etx arbiter priority to increase stability
-created the esaxi_mux block
-fixed some missing ports issues in stubs
Now comes the fun part...verification...
Andreas
