Changes are mostly in the RX logic, where RST_IN was still used, though some new
logic (reset_extender) was added to riffa.v. Updated projects for: VC709, VC707,
ZC706 (partial), NetFPGA, ADM-7V3, ML605 (Still not working), AC701 (Untested)
and KC705 (Untested)
In riffa.v, the interrupt module was getting data from the TXC_DATA, which didn't match the assertion of the ready signal from the registers module. Changed to _wTxcData.
In tx_data_fifo.v, changed the DATA_READY signal to connect to the fifo instead of the packet counter.
In the tx_engine, removed the curious case of the +1 in the data fifo packet depth
The error occured when calculating the actual header fifo depth,
C_ACTUAL_FIFO_DEPTH. This was initially clog2(C_FIFO_DEPTH), but should have
been 1<<clog2(C_FIFO_DEPTH).
This does not fix the user bug, which occurs in the 64-bit interface. I suspect
this is a data under-read/over-read error in the data fifo but I have yet to
confirm it.
The graceful reset logic splits the RST_IN port into the RST_BUS and RST_LOGIC
ports. The RST_BUS port is for when the entire PCIe (or whatever) bus is
undergoing reset and the RIFFA logic should not worry about corrupting any state
by terminating a packet early (causing a malformed packet). RST_LOGIC is for logic resets, where PCIe state is not affected and may be corrupted by a malformed packet.
The reset_controller module will safely reset a single stage pipeline without
using an asychronous reset (bleh). It is intended for use in the TX engines,
where it will control the output stage of the engine, and provide a gracefull
end-of-packet reset.
Bug caused received 128-bit Request Headers without payload to signal data word valid one cycle early. May not be a final fix. Unlikely to affect current users.
Expanded DONE_RST into four signals, for each of the four engine interfaces. In
the ultrascale engines, wired up all of the RST and DONE_RST signals. Quickly tested the logic in a power-on-reset like situation, no guarantees on graceful in-transmission resets. Classic engines will have to wait.
Still need to propagate the changes and hook the resets up in the formatters,
multiplexers, etc. RST_BUS will be the equivalent of a PCIe PERST Pin reset, a
general inelegant reset where formatting is disregarded. RST_LOGIC is a reset
caused by application or higher level logic, where formatting needs to be
considered so that the bus does not lock up. DONE_RST will signal that the
engine layer has finished resetting, and is ready to transmit data.
The C_VALUE parameter sets the reset value of each bit in the shift
register. All bits will get the same value, individual setting of reset values
is not implemented.
